:   Archive home

Introductions

  »

Hello

   ( >> )
frostydeeps - 05 Jul 2008, 06:08 am
Found this site on google and was reading around until i found exactly what i wanted.

Decided to join this site as a registered member to get access to "Running a security business" and "Dealers Only" Section...

Plan to start my own business in the future, pretty soon though... Will be in India. Have a lot of questions so will be around a lot.

Thanks.
frostydeeps - 05 Jul 2008, 07:11 am
Any idea how i can get access to those two forums? Whom do i contact?

Thanks.
scorpion - 05 Jul 2008, 02:36 pm
You contact the site admin

QUOTE:
Private forum for registered CCTV Dealers, Manufacturers and Installers. Contact the moderator with your credentials for entry.
Note: You must have a minimum of 25 posts before seeking entry.


Here are some articles to read

BUSINESS / MARKETING
http://www.cctvforum.com/cms_articles.php?cid=5

There really isn't much going on in those "locked out" forums. Everything is pretty much out in the open areas. The only time the closed off section is used is if we are talking about wholesale pricing, or we have a vendor question.

Do be to disapointed once you finally get access to the locked out areas.
frostydeeps - 06 Jul 2008, 12:33 am
Wholesale pricing is what i am looking for. I will be needing 100-200 cards once i get my loan approved here. So a good price is what i am all about.

will contact the site admin too. thanks
scorpion - 06 Jul 2008, 10:18 am
You are going to get some serious spam now!!
RickA - 07 Jul 2008, 08:35 am
Hello and welcome to the forum. Actually use the Dealer forum to poke fun at scorpion...shhhh! don't tell him. :D
scorpion - 07 Jul 2008, 07:28 pm
You are too funny!

(under breath) mumble mumble mumble@#$%
kalpesh_nikumbh - 07 Aug 2008, 06:38 am
Hey scorpion!!

So what happen to him then??
is he got the access there???


Kalp. :)
scorpion - 07 Aug 2008, 08:03 am
I truely do not know.

I am out of the loop.
RickA - 07 Aug 2008, 08:24 am
Hey Scorpion, where have you been?
scorpion - 08 Aug 2008, 09:33 pm
Boring a Horizontal Shaft with a paddle bit, and 12" snap on extensions through the vent holes on a flat roof.

I must have bored through about 15 rafters!

I used up to 7 of these to drill!

http://www.irwin.com/irwin/consumer/jhtml/detail.jhtml?prodId=IrwinProd100181

http://www.irwin.com/irwin/consumer/jhtml/detail.jhtml?prodId=IrwinProd100186

http://www.irwin.com/irwin/consumer/jhtml/moreImagesPopup.jhtml?prodId=IrwinProd100181&moreImage=Alternate_Image2

(note: I recommend 3/4 bits)

I may have to change my motto " No Job To Hard "!
newgirl65 - 19 Aug 2008, 04:24 pm
Sounds cool. Good luck! :D
Fisherlee - 21 Aug 2008, 03:36 am
Hello, welcome.
Banner