Built a new system:

GV-1480 V8.2
Gigabyte GA-G31M-S2L motherboard with Intel GMA3100 onboard graphics.

Intel E7200
2 gigs ddr2800 ram

Plugged into my existing cameras that have been hooked into a gv1000 using 6.0 software.

The video is much smoother than the GV1000 I have in place. But.. When viewing a single camera (#1), the video is shimmering or looks shakey.

I cannot enable direct draw overlay, or it's grayed out.

Any ideas? I'm thinking the onboard graphics are not good enough. I thought I had used this onboard graphics with versions 8.1 or lower software and didn't have any issues. Suggestions and thanks.

A little more goofing around.

Found if I disable DSP the shimmering goes away but the video is not as smooth. It's incredible how good it looks with the DSP turned on but anywhere there is a lot of light or even looking down at a row of pegboard hooks from the top, they seem to shake.

With it off, that goes away but the video is nowhere as smooth.

Anyone work with this yet?