DSP in new 1120 machine we just built is being used for monitor for public view,
The dsp flicks through the 3 cameras not being used and shows a black screen instead of jumping back to cam1 etc,

Geovision have been made aware of this issue, waiting for a fix.

"It will display a black sceen for the interval time on camera's not selected. There needs to be a skip camera option. It appears to be a software issue,"


My supplier replied with this
" think we have found the problem.
Being a software multiplexor it isnt skipping the channels properly. We just found the same problem on a GV2008 system with a multiquad card."

are those channels disabled?

Are you actually using DSP as the spot monitor controller ?

If so, then you need to go into the Spot Monitor Controller setup, Video setting tab and disable the unused channels there.

OK
I should have mentioned
this is not the first time I have installed gv cards
this is not the first time I have setup dsp

THIS is a fault with the sw it has been tested
I was just letting yall know


I have setupo many gv systems since 2004 and I know them backwards..


cheers
:)

Maybe that's the problem, try putting them in the other way .... :lol:

Done, done and all done guys
this is a fault with this sw version,


Trust me, I have doubl checked and rechecked everything, there isnt much to do for DSP setup :)