Jump to content

veetek

Members
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. As in the subject I have a dahua hybrid dvr and have both analog and ip cameras connected to it , when I set up motion detection , it works all good on the analog ones , but ip seems to struggle detecting motion , it sometimes starts recording too late and always cuts the video short ie. I have one of the cams pointing at the driveway and it can see me going and getting into the car in the morning but it wont record car leaving from the driveway. I have anti dither set to 5s delay set to 10s (all default parameters that work good with the analog cams) thank you for any suggestions that you might have. V
  2. Tom, the side with the existing analog system has the dvr with two analog ports open , and they told me the want those 2 cameras from the location 5 miles away hooked up to those 2 ports. so using a software and a pc on their side is out if the question( just because they dont want to) is there an encoder and decoder couple that I can use to transport the video signal over the internet ? Thanks
  3. Thanks for a quick reply, I am aware that it is going to be expensive. Unfortunately I cannot change or replace any devices. So if you guys have any other ideas Id appreciate it. Thanks a lot in advance
  4. Do you guys know what equipment to use ? on one side I have couple of analog cameras and on the other side I have analog DVR I just want to convert the analog signal into IP then transport it over internet and decode it back so I can feed it to the analog DVR. Thanks a lot for all your help. Veetek
×