Jump to content

Fluke

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Hello Guys I was having similar issues but finally manged to get it working, was wondering if you experienced the following. If I set the system up on the bench supply I can control my samsung camera via my control, over coaxial cable. However when I install the camera say 50 meters away I cannot control the Camera at all either by the control or through the DVR onbard PTZ controls. The picture I am getting is crystal clear. What could be my issue, where should I start?
  2. Hello All I have the following Kit 1. Samsung SPC-1010 controller 2. Samsung SRD-1650 DC DVR recorder 3. Samsung SCP-2370 THP Camera I can connect the controller directly to the camera and all PTZ functions work correctly. What I need to do is connect the controller to the DVR and the camera into the DVR, so effectively i send the ptz command to the DVR which in turn sends it to the camera. (this way we can extend the system to multiple camera and control all cameras) I believe the camera is one which uses the coaxial to transmit the PRZ commands. ON THE DVR I HAVE THE FOLLOWING: TX + & - RX + & - on the controller there is TRX + & - TX1 + & - TX2 + & - TX3 + & - So how do I connect the the Controller to the DVR?
  3. I am heading in the right direction now further reading after searching "coaxitron" make the matter a lot clearer. Is there an adaptor I can use to connect these panasonic camera to the following controller? http://www.meritlilin.co.uk/assets/Keyboard%20Controller%20(PIH-800II).pdf Or am a barking up the wrong tree?
  4. Reading further into this I believe that the coax cable send the video AND the telemetry date through the SAME cable. I am now hooking up a controller to see if I can access the setup menus. Please still reply if you can offer any guidance.
  5. Hello Guys I am new to this forum and would like to say big hello to all of you. Right down to the nitty gritty I have 2 units of the Panasonic WV-CS320, The link below will take you too a PDF version of the user manual. http://www.ecdltd.com/manuals/panasonic.pdf I can get power to the unit fine and the video output is also fine, problem I have is how to I set the camera up it is currently doing a 360 pan and I need to edit this plus other settings. How do I get to the setup menu? According to the manual I should use a controller to enter the menu, this is the problem I do not have one. Do any of you have any experience with this model? This link http://www.info4security.com/story.asp?storyCode=1038157&sectioncode=9 states that the video cable also carries telemetry data I have split open the unit and can see at least 14 cables however a visual inspection along with a continuity test confirm these do not enter the camera unit. Any guidance or help would be much appreciated.
×