Jump to content

Kevin75135

Members
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Kevin75135

    GV-FER521 Fisheye View

    I purchased a GeoVision GV-FER521 system to install on my GV-NVR. When I view the camera in default (raw) mode, PIP, or PAP mode, the image is fine, and I can see the full 360 degs.. However if I select Geofisheye view, no matter what view I select, the image stays centered on a particular area of the room. Any attempt to change the angle of view just results in the image spinning. In single view mode, the PIP image is a circle much smaller than my other fisheye cameras, and is sliced off on the side. In 360 deg mode, the bottom image which is supposed to show everything only shows about half of the image. I have tried setting the camera to different Fisheye cameras in the IP camera install utility, and my settings for camera position is correctly set to ceiling. Does anyone have any ideas on how to get this to work? My GV-FE2301 and GV-FE520s work fine.
  2. Hello. I have a unique installation in which I will be using a NVR to capture medical simulation within a nursing school environment. Not only will I need to have the students actions recorded, but also the simulated patient monitors, as well as the laptop monitors that are used to control the manikins that simulate symptoms. This capturing needs to be time synchronized to the video with the ability to fast forward and rewind, so just saving the screen to a local file will not work. Is anyone aware of an application that can take what is displayed on a computer monitor and send it out on an IP stream that an NVR can attach to and record? Thank you. Kevin Green Simulation Laboratory Coordinator Texas A&M University - Commerce
×