hendrik6073

i think that would work. trick is the private protocols, seems like every brand uses different. load als much possible and you get more fully (with motion detect, area setting, etc) cam's working on the system

okay good ! there is also a recovery image when device is bricked

https://www.dropbox.com/sh/ggnp0vodplxux7q/AADuEJzbEWcBUJ7U6ZkNeIY2a?dl=0 here a whole badge of protocols, software, updates etc; https://gofile.io/d/0Ml24D

reload firmware ?

Hi, lots of information in here ! What i coud not find, scanning all the posts is if there are some sort of alternatie firmware's out there. I would like to embed the stream of 1 of my camera's in a website (domoticz / frontpage). Onvif camera's i have do support rtsp that i can connect to using vlc plugin. This plugin is not supported on my android tablets in combination with image on website. . I am looking for a way to use the NVR to serve the image that want, nothing i the original firmware so searching for alternatives. thanks.

seems like the problem other camera;s got with onvif. set motion detection sensitivity, save succes, after leaving and going back settings are gone. Same with displaynaam, time settings etc. using camera's with other protocols doing fine, i've i8, i9 and i13 working

would it be possible to redirect de record folder to a network share, now the OS of NVR is a read only one ?

if you do so, place the cam in a place were you can be sure all movement is alarm worthy. Cams can be quit nervous where it comes to motion detection. It might give you a lot of fals alarms

there a lot of ways imageble. best is to connect to the cam, it would also be possible to just send a e-mail message and have the receiver of that mail run a script that acitivate something. this would not be as fast as connecting direct to the cam

can somebody repost the credentials to set up a telnet connection with NVR ? it was as a link on this board, not working anymore

i dont think so, i think you have to connect those to the cam itself

anybody know how to factory default a bullit cam ? mine is in a reboot loop, can't ger it out

or USB

i have enabled send mail at motion detection function on all camera's. some send attachement, some don't anybody else with same behavior ? thanks

no it is not a .RAR, just update under settings using the file, than reboot.