pjwinstalls

Ok...did this... internet worked normally and cameras were accessible for about a day and then same problem occured... internet stopped working until camera server unplugged. any other suggestions??

I attached two pictures....one from the NVR and the other from the router. The the port forward of 35006 in the one i manually put in, the others below that are ones that are being put in from the NVR via UPNP. thanks for the help..... I am used to doing dw spectrum and hikvision nvr.... this one is foreign to me.

I have a DNR400. I also have a fios router. Port 35000 is being used by one of the fios set top boxes on my network so i changed the port to 35006 and forwarded the port. When i do this...i can view the cameras sometimes but i can no longer pull up any websites on the computers on the network. most of the time, i cant access the cameras remotely at all and the internet stops working. As soon as i unplug the NVR....my network starts operating normally again.. Any thoughts on what could be causing this? Thanks! Philip

Ok...i see the problem but i dont know whats causing it. On the hikvision config page, i increased the max bit rate to its highest allowable.. 12228. When i look at the image coming from the cam in the digital watchdog software....its coming in as 10mb-12mb which is correct. But in milestone, ... its fluctiating between 3.5-5 mbit/s...no matter what i set the max bitrate to on the camera. Why isnt milestone accepting the full bitrate that the hikvision is putting out?

CPU utilization is only at 10%....even if i run DW spectrum it only goes to 22%. Network utilization is only 1.7%. Iframe is set same as the frame rate and my max bitrate is actually at 8311. Like i said, the video on them is great with the other software on the same computer.

I am using milestone essential and have two hikvision ds-2cd2332 cameras running at full resolution and 20fps. Whether i am watching the feed live or playback through milestone the video is dropping frames and isnt smooth. If I connect directly to the camera its fine. I also downloaded DW watchdog spectrum and again the video feed is fine. I also have some clients with these cameras and the hikvision NVR and video is fine. Problem is only when viewing with the milestone software. Using the hikvision8x3 driver and I have updated the both cameras to the latest firmware. Paid a lot of $$$ for milestone so would really like to get it to work properly. Milestone tech hasnt been any help..... Suggestions??? Thanks Philip