Hi,
I recently flashed 3.0.10 firmware onto the device and noticed that it has bricked it.
Got the firmware from Hikvision global website version.
File: Baseline Firmware_NVR (76NI-SE)_En_V3.0.10 141125
Before this I was running V2.3.10.
The device now goes through the following:
- Power up (power light green)
- Double Beep
- Hikvision NVR Splashscreen
- Flashy rx/tx light
- Flashy status light
- Dead (no leds expect power on the front, and display signal dies too)
All this while I was running a continuous ping on the device. It responds around the splash screen and then dies around the same time as the display.
I was hoping if there is anyway I can restore it back to the previous firmware or perhaps fix this?
Please advise.
