Jump to content

ilovetacos1756

Members
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. ilovetacos1756

    Distorted image problem, any ideas?

    Camera is running over Genesis RG59-18/2 Siamese. Wire run is approx. 275'. Oh, BTW did I mention the camera is 40 feet in the air? Which makes troubleshooting tougher.
  2. I installed a system for a client 4 months ago that included four CM-512 Open Eye PTZs. They are connected to an Open Eye DVR. I returned to add two more PTZ's and all was well. About two months ago one of the cameras developed an issue. The image became very distorted and blurry. I replaced the camera with a factory replacement. I have replaced the BNC's on both ends of the cable. I installed ground loop isolators on all cameras in the system. I moved the power connection to a new output on my Altronix 24vac power supply. The PS is a 16ch unit of which only 8 are being used. After my last trip to the site the camera looked great for three weeks and now the problem has returned. If i reboot the camera it will look okay for 24-48 hours and then overnight will revert back and look like junk. I am out of ideas and my customer is losing patience. Has anyone seen this before?
×