Jump to content

StefDahua

Members
  • Content Count

    9
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. StefDahua

    Dahua firmware

    Anyone know if there is an online repository with the latest Dahua firmware update? Thanks Stef
  2. StefDahua

    Motion detection problem Dahua IP TLC

    Anyone can please help with the MD configuration? Thanks
  3. StefDahua

    Motion detection problem Dahua IP TLC

    iDMSS Lite is now back to working correctly without any change, so it was a Dahua problem. Still have the Motion Detection issue. All support is appreciated. Thanks to all Stef
  4. Hi, I have a problem with the motion detection setting for my 5 Dahua IP TLC. They are all configured and connected to a 8 PoE Dahua NVR. All channels are recording but only 1 camera make the MD. I try to copy this camera setting to the others 4, but still the same one do the MD. Anyone can help please? P.S. Actually the iDMSS Lite app on my iPhone is not working outside. Locally with WiFi it works. Anyone can confirm this? Thanks in advance and best regards. Stef
  5. There's no article there...
  6. Hi everyone, just solved the issue. The VTO2000A need a 12V DC power with at least 1A on PIN 1 and 2 because with only PoE from the switch, the current is not enough to open/unlock the door, and this cause the shut down of the VTO and restart of it. Adding separate and dedicate 12V DC, it works fine!
  7. Thanks you so much, I really appreciate your support. Looking 4 your test results. Regards Stef
  8. I've just tryed to modify the time of opening (from 1 to 5 sec) and wait time from 15 to 1 sec but nothing change. Don't think VTO is broken. Probabily something else in the config or maybe wrong connection from VTO to electric lock?
  9. Hi everybody, I have 1 VTO2000A + 1 VTH1550CH (set as master) + 1 VTH1660CH (set as slave) + 1 switch VTNS1060A + 1 power supply VTP2406. All of these devices has been installed and configured. VTO firmware is: General_Multi3_VTO2000A_EngRusItlFreGetDutSpaPor_P_16M_V3.100.0000.0.R.20160622 VTHs firmware are: General_Multi3_VTH1510_EngRusItlFreGerDutSpaPor_P_V3.100.0000.0.R.20160622 The problem that I have is that once the call is coming from the VTO, if I open from any of the VTH panels sometimes open and sometimes no. Also, even if they open the outside door, looks like the VTO goes offline and the panel freeze for about 5/10 seconds. Then I can't open again or see the MAIN VTO image for at least 2 minutes before I can operate again. Can anyone suggest me something to fix this problem please? Thanks in advance for your support. Regards Stef
×