Jump to content

veronicastyles647

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. We had a power outage and the Swann DVR when it came back on apparently reverted back to default settings. Before the outage it was set to continuous record and when it came back on it is now on motion detection. When I reviewed the motion events many of them seem to be working fine...recording all motion and a few seconds or so after. Other times the recording stops in the middle of obvious motion. The very motion that set it off in the first place. Can a power outage cause something on the hard drive to act up like this? I know very little about the technical side of this even though I have had MANY issues with this system since installation almost 1 year ago.
×