 |
|
 |
Problem: PTZ Cameras drift after control
|
|
|
| kzinaz |
|
Posts: 1
Joined: 11 May 2008
|
|
Posted: Sun May 11, 2008 3:22 pm
Post subject: Problem: PTZ Cameras drift after control
|
|
The system is a Honeywell (Ultrak) HMXAT200 Switcher, HEGS3500 Keyboard, and 32 Honeywell KD6 PTZ cameras. The system was working properly. Recently, all PTZ cameras will continue to move slowly after they're panned. If you're panning a camera with the joystick to the right and release the joystick to stop, the camera will continue to pan slowly to the right. A slight bump to the left will generally stop the drift. I'm using the MaxPro protocol. I thought I might replace the RS485 board in the HMXAT200. Any other suggestions?
|
|
|
|
|
|
|
| griffonsystems |
|
Posts: 365
Joined: 15 Aug 2005
Location: chicago
|
|
|
Posted: Sun May 11, 2008 9:58 pm
Post subject:
|
|
try recalibrating the keyboard, how are the ptzs wired? homerun or daisychained?
|
|
|
|
| VST_Man |
|
Posts: 1293
Joined: 16 Oct 2004
Location: St. Helena Island, South Carolina
|
|
|
Posted: Mon May 12, 2008 7:31 am
Post subject:
|
check the power...seen this where the camer distance from the power supply is to long. I normally use adjustable power supplies so can adjust/compensate for cable distance........works very well. ie. 15vdc adjustable used on a 200ft. connection, adjust the power to 14vdc so that the end of the cable voltage is 12vdc. ie. 28vac adjustable....same same.
_________________
"you get what you pay for"
|
|
|
|
| UMDRanger |
|
Posts: 267
Joined: 23 May 2005
Location: Minnesota
|
|
|
Posted: Mon May 12, 2008 8:10 am
Post subject:
|
|
I second the controller calibration. Might also pop it open and make sure no debris is getting caught on the buttons/scrollers inside the controller.
|
|
|
|
| cwd10 |
|
Posts: 22
Joined: 19 May 2008
|
|
|
Posted: Mon May 19, 2008 5:03 pm
Post subject:
|
If none of those other suggestions PAN out  , I would also check the Joystick/gimble to see if it's getting bound up with dirt or debris. They can get pretty gummy sometimes. I have seen this happen a lot in harsh environments. Also could be the pots (potentiometers) gunked up inside. a good electronics cleaner should help with both of those.
|
|
|
|
| BartMar |
|
Posts: 3
Joined: 20 May 2008
|
|
|
Posted: Tue May 20, 2008 2:32 pm
Post subject:
|
|
Might also see if stop commands are getting to the cameras. Have seen that with Ademco (now Honeywell) cameras. Fix? Antenna realignment. If you're lucky. Hope some of the other suggestions work for you first.
|
|
|
|
|
Options and Permissions
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum
|
| Page 1 of 1 .:. |
|
|
|
