Jump to content
g4lrg

Configuration of iVMS-4200 after PC Crash

Recommended Posts

Hi - I'm new to the forum and have an issue of getting the PC software running after a PC rebuild.

The Software was originally installed as New with Recorder and 2 cameras earlier this year but the company have now gone bust so I am struggling a little with getting visibility of the cameras on my PC again.

I down loaded the software iVMS-4200 and installed it ok (I think) but I cannot see anything from the cameras at all.

I know the original setup had some port forwarding setup on my router and this is still active. I added the IP address to the Device management configuration along with password etc and it shows up ok as far as I can see, but when I go to the main view (4-Screen) there are no images from the cameras.

Can anyone tell me what I'm doing wrong please?

 

I should add that on my iPhone and iPad, I can still see the cameras ok - its only on the PC setup that I am having issues.

 

Thanks in advance for any assistance.

 

John

Share this post


Link to post
Share on other sites

After a lot of fiddling about, I have worked out how to get this going using port forwarding and all is looking good.

I consider this issue closed

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×