Jump to content
Sign in to follow this  
abdulelahshmaisani

hdd of my dvr is not recognized

Recommended Posts

I have a dynix dvr that was not recording to a problem with hdd the system show a message says wait disk for repair such that I could not enter to the menu at all to do something like format the hdd of buck it so that I remove it from dvr and make a format on pc then I back it to dvr but the hdd not recognized and dvr disconnect and reboot a gain and again how do I solve such problem

Share this post


Link to post
Share on other sites

Hello. Making sure there is adequate power for both the DVR and HDD would be the best way to start. If you simply disconnect the HDD from the DVR and try to boot up the DVR without the HDD connected could rule out the DVR as an issue. Just be sure you put the cover back on the DVR before you try booting up with the HDD removed or disconnected. If the DVR is OK it should not reboot with the HDD disconnected.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×