Server upgrade postponed



View unanswered posts | View active topics


Reply to topic  [ 1 post ] 
Author Message
  
 Post subject: IP cam IR Cut ... activate it without an IR board ???
PostPosted: Wed Jul 29, 2015 12:40 am 
Registered User

Joined: Jul 2015
Posts: 5

Offline
I have some no name IP board cameras and would like to use them without IR boards as the area is already covered with plenty IR, (too much is bad as too little) but how can one activate the IR cut filters without use of a matching IR board. ??

Second question- in fact I did buy an IR board which also came without wiring and I'm not sure how to hook up the filter trigger wire, in addition to the power connector it has a smaller 2 conductor socket for this purpose of which only one (the+) conductor is sometimes used, easy enough. The cam however has a 3 pin unused socket and I have no clue which one ....(or two) pins to use and there is no + or other marking on it. Seller can't or won't advise. I plan to solder the wire rather than waste time trying to find the right harness and then wait yet another two months to see if it actually comes. Anyone know for SURE how to ID the pins without a datta sheet ???

Thanks.


Top
 Profile  
Reply with quote  

Display posts from previous:  Sort by  
Reply to topic  [ 1 post ] 


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

It is currently Tue Sep 25, 2018 6:33 am

The contents of this webpage are copyright © 2003-2016 CCTVForum.com. All Rights Reserved.