Jump to content
Sign in to follow this  
towersites

Pelco net300

Recommended Posts

I still have a few NET300R's and NET300T's running on a network. They continue to work OK but I have a few additional units in storage at the shop that I cannot reconfigure. For example I can access a NET300R with a laptop running Windows 7 through an ethernet cable, I can see the General Setup page no problem, but if I click on any of the subpages such as Network Setup or Video Decoder Settings, it brings up a page that is mostly blank, the area where I used to see configuration and other data is just blank. I used to be able to access these with an older laptop running XP. Has anyone seen this particular issue? I can send a screen shot if someone wants to see what I'm seeing.

 

Terry

Share this post


Link to post
Share on other sites

This can be a number of things primarily the security levels of windows 7.

In past i have had to set up active x to run as unsecured ie minimum restrictions to get the active x components to load

 

Also set ip address in as a trusted site.

Possibly use f12 on internet explorer and set to run im emulation mode of ie8 etc

And even set the ip address as a trusted site under java controls .

Windows 7 is most likely causing the issue.

Try googling each of the above.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×