Jump to content
shlomishm

Dahua NVR Reboots (Reset Flag 0x6)

Recommended Posts

Hi,

 

I bought Dahua NVR416-8P-4k from Aliexpress.

The device arrived after a week completely sealed, no opening signs.

At the beginning everything was good until it started...

The device reboots all the time. Sometimes every 2 minutes and sometimes every 30-60 minutes.

The reboots seem to be randomly to happen.

The common to all these reboot is the same reason - flag 0x6 and I have no idea what is the meaning of it.

I tried to debug and I did the following experiments:

1. Disconnect the IP cameras

2. Disconnect Network cable

3. Disconnect HDMI cable

4. Remove POE card

5. Remove HDDs

 

Eventually the NVR remained with motherboard only and still reboots didn't stop.

I've already upgraded to latest FW and did configuration reset and factory reset.

None of the experiments above solved the problem.

I got no response from Dahua support and the seller ignores my existence.

I'm despaired and frustrated. **Please help** .

 

Thanks,

Shlomi

Share this post


Link to post
Share on other sites

Hi. Ox6 is wrong region firmware.

 

With your unit booting every few minutes means you must of done a firmware update before your problems started......otherwise your unit would not run without booting before you could change the firmware.

 

Aliexpress is your best to talk with if seller is not responding

 

Dahua will not help direct.

Share this post


Link to post
Share on other sites
Hi. Ox6 is wrong region firmware.

 

With your unit booting every few minutes means you must of done a firmware update before your problems started......otherwise your unit would not run without booting before you could change the firmware.

 

Aliexpress is your best to talk with if seller is not responding

 

Dahua will not help direct.

 

Thank you, Tom for replying.

I asked the seller to send me a FW that match to my country, I hope I'll get it soon.

But... I don't understand... Why the region should bother me anyway? The menus are fully supporting English and the I'm able to configure my timezone. What am I missing?

 

Thanks,

Shlomi

Share this post


Link to post
Share on other sites
Hi. Ox6 is wrong region firmware.

 

With your unit booting every few minutes means you must of done a firmware update before your problems started......otherwise your unit would not run without booting before you could change the firmware.

 

Aliexpress is your best to talk with if seller is not responding

 

Dahua will not help direct.

 

Thank you, Tom for replying.

I asked the seller to send me a FW that match to my country, I hope I'll get it soon.

But... I don't understand... Why the region should bother me anyway? The menus are fully supporting English and the I'm able to configure my timezone. What am I missing?

 

Thanks,

Shlomi

 

 

 

So where did you get the first FW ?

 

I've already upgraded to latest FW

 

FW needs to match the software on your system ..... Wrong FW is none reversible........ We're are you based

Share this post


Link to post
Share on other sites
I took it from Dahua's website.

I'm from Israel.

 

 

Was it v3.203 ?

 

 

No, the version I upgraded to is 3.210.0005.0

Assume the seller sending me a local FW, can I flash it with no issues?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×