Jump to content

Recommended Posts

Hello, all.

 

Apologies if this has been discussed before but, I haven't found the thread in the forum.

 

I have several DS-2CD2142FWD-l cameras three of which are running through one network cable into the router and then out to the HDR. The fourth camera is plugged straight into the HDR. Because of a network issue, I had to power down all the three network routed cameras and then reboot that part of the network.

 

Two out of the three cameras came back nicely but the third did not retain its orientation settings. When I go into its own config page I find I can adjust the mirror of the image setting but I cannot rotate the image. So, I tried going into the HDR config menu and again, I can adjust whether the image is mirrored but it just will not rotate. Am I doing something wrong? Any thoughts from you would be greatly appreciated.

 

Ben

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×