Jump to content
gianrico

fh8810 + sc1145 bootstrap image

Recommended Posts

Hello

i have bricked my ipcamera while experimenting with it.

It is a chinese one with fh8810 + sc1145.

I was wondering of anyone in the forum owns one of these and is able to read the flash from address 0x0 to 0x10000 which holds the bootstrap code.

 

I had made a backup of that partition (mtd0) and the others, but unfortunately the virtual machine with linux holding the backup died. So i have lost the backup. Nice!

 

The cam uses an app called liveyes. The firmware inside was apollo.

 

If you have one of these, the serial port can be found on the bottom side. You will find TX1 and RX1 and GND marked on some testing points.

 

If you are confident with accessing the console of the device, you can mount an nfs disk and then use the mtdt binary onboard to read mtd0.

 

I hope i will get a reply from someone as i do not want to throw it away.

 

thanks

gianrico

Share this post


Link to post
Share on other sites

Guest

Hey man.. I have 3 such cameras. 2 of them have gm8135s + sc1145 and one is with fh8610. I was able to fully modify those 2 with gm8135s. Now i am connected to fh8610 on serial, but all i get is

 

ROM ERROR NO: 217

ROM: Ok.

Than camera produce the sound if i hold reset button i hear the reset sound, so the kernel must be running. Can you tell a bit more how you manage to get to the console with serial.. Thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×