Post subject: Qvis 4 Channel DVR - Monitor and Spot
Posted: Mon Dec 12, 2011 5:31 pm
Joined: Dec 2011 Posts: 8
Hello,
I'm in the process of changing out a unit with a recently purchased 4 channel Qvis unit...the unit that's being replaced has two monitors connected to it:
Monitor 1: 4 Channel Grid View Monitor 2: Rotates between all 4 cameras...
How do I connect these two monitors to the Qvis/Dahua to accomplish the same task? I have one connected via VGA, and the other via BNC but they display the same image on both...
Post subject: Re: Qvis 4 Channel DVR - Monitor and Spot
Posted: Mon Dec 12, 2011 6:42 pm
Joined: Feb 2010 Posts: 926 Location: Chapel Hill, North Carolina
Yep, thats how it works with my Qvis.
What you do is go into Display, and enable a Tour, say 1 view (one camera shown on screen at a time), and cycle between all every 5 seconds.
I have done similar, with motion set up to bring the camera up on 8-view, one enlarged. Then the normal tour function brings it back to 9-view after 6 seconds.
Post subject: Re: Qvis 4 Channel DVR - Monitor and Spot
Posted: Mon Dec 12, 2011 6:55 pm
Joined: Dec 2011 Posts: 8
Is that "tour" occuring on one screen while the other screen shows the 4 view grid? Or are you saying that the Qvis device cannot use a second monitor to perform that task?
Post subject: Re: Qvis 4 Channel DVR - Monitor and Spot
Posted: Mon Dec 12, 2011 8:57 pm
Joined: Dec 2011 Posts: 168 Location: Taiwan
lselfstorage wrote:
Is that "tour" occuring on one screen while the other screen shows the 4 view grid? Or are you saying that the Qvis device cannot use a second monitor to perform that task?
Thanks
Hi it is normaly design two output for one is main to remote and control and spot is only to monitoring watch.
Users browsing this forum: No registered users and 4 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
