Jump to content
adamxp12

Dedicated Micros SD8N30 Codec Fail when upgrade unit

Recommended Posts

Ok here is the story

I have a dm sd8n30 (M3S) that was running with the 4.2 firmware

I stupidly decided to want to upgrade to 4.3 and now that I have done that my dvr wont boot

don't output a signal to the screen and if I telnet into it it says "Codec Fail"

 

also if I go to the web interface it is still showing version 4.2??????

I differently put the right firmware onto my usb drive and I did put all the files on it and followed the guide that dm give you but it seems to of bricked my dvr

 

Any Ideas?

Share this post


Link to post
Share on other sites

I think best will be find same unit and copy all the files into yours. To double check do you have unit with round front panel without buttons ?

Share this post


Link to post
Share on other sites
I think best will be find same unit and copy all the files into yours. To double check do you have unit with round front panel without buttons ?

 

Yes looks like one of the older ds2's but without any buttons

Edited by Guest

Share this post


Link to post
Share on other sites

I should have somwhere working sd unit I will check this weekend. All data should squeeze on dvd so i can send you one. All you need to do is copy everything to your hard drive.

Share this post


Link to post
Share on other sites
I should have somwhere working sd unit I will check this weekend. All data should squeeze on dvd so i can send you one. All you need to do is copy everything to your hard drive.

That would be awesome if you could do that for me

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×