Jump to content
Sign in to follow this  
BWATL

Advice on failed Swann HDR8-8200 (HD-SDI)

Recommended Posts

Around 2012-2013 I purchased and installed a Swann HDR8-8200 8 channel DVR system that is unfortunately an outdated SDI system. That said, the system has worked reasonably well. I have 7 1080P bullet cameras, and one 20x zoom PTZ camera. I like the PTZ camera. The system is very cleanly installed and all of the wiring is hidden behind the walls. That said, I could run the wiring for IP camera for all but one of the cameras, which was wired when I had the drywall out of one of the rooms, and then I spray foamed the ceiling and walls after the wiring was done. So I have 8 BNC cables in place. The old Swann SDI DVRs are extremely rare these days. I'd like to fix or replace mine, but I'm not sure what all is wrong with it. I know one of the hard drives is failing.

 

Manual for the system I have: https://www.swann.com/downloads/product/2299M88200H210313E_web.pdf

PTZ Camera: https://www.swann.com/us/coshd-d1080x1

 

Options

1. Fix the system I have. Not sure how feasible that will be yet.

 

2. Find a comparable DVR that supports SDI such as a Hikvision or Dahua. I'm fine with this option if there's something available that supports my PTZ camera and has an app I can use remotely. Installation will be easy since all the cameras and wiring are already in place.

 

3. Start over with a newer system that can still use the BNC cables. May lose the PTZ option. Would still be going with an older technology, but seems less expensive than the IP option.

 

4. Bite the bullet and start over with an IP system.

 

Thanks in advance. I welcome any suggestions.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×