Jump to content
bomberb17

QSee QC448 does not turn on

Recommended Posts

Hello,

I have a QSee QC448 DVR, and it has been working non-stop flawlessly for over 5 years.

Suddenly for no apparent reason it stopped working (I received my last motion alert in around 1am during the night)

I went on-site to see what's going on. The cameras/cables were all intact. However on the DVR, the "Power" status light was flashing on the front. I tried powering it off and on again after a while, but it would not boot again (and was not making the beep sound when it boots), and the same light was flashing again. Disconnected all cameras/monitor/mouse/LAN cable, leaving only the power cable, still the same.

What can I do? Does this suggest a faulty hard disk or is it something worse than that?

Thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×