Steve Sarre 0 Posted July 12, 2007 Hi all I installed my first 3 home security cameras today and they initially looked fine, however, over the course of a few hours they started going dim, if I power cycle them they bounce right back to full brightness. Any advice on how I might fix this would be greatly appreciated. Dan Share this post Link to post Share on other sites
Steve Sarre 0 Posted July 13, 2007 Hi all I installed my first 3 home security cameras today and they initially looked fine, however, over the course of a few hours they started going dim, if I power cycle them they bounce right back to full brightness. Any advice on how I might fix this would be greatly appreciated. Dan Never mind I did some further reading and found the problem was due to voltage drop over the cable run, I hacked up some transformers to provide a higher voltage / ampage and the problem has been resolved. Just though I'd post in case anyone else had a similar problem. Share this post Link to post Share on other sites
scorpion 0 Posted July 14, 2007 How far was your run? What kind of cables were you running? Just curious. Thanks! Share this post Link to post Share on other sites
chad_cooper 0 Posted August 10, 2007 Maybe he had one of your nanny cams... JK Share this post Link to post Share on other sites
Rebco 0 Posted April 11, 2008 I hacked up some transformers to provide a higher voltage / ampage and the problem has been resolved I am sure that this is what every customer wants to hear..... Why not do it right? Share this post Link to post Share on other sites
