Jump to content
mateck8888

Need NVD4VIEXT Aver 4CH Extension card for NV5000 card

Recommended Posts


Hmm... I bought one not that long back, but looks like everyone's out of them.

 

You can wire up your own pretty easily. The header for the card is 10 pins; 2 pins at one end enable the extra 4 channels with a jumper, and the other 4 pairs are signal and ground for the 4 channels.

 

I forget which end is the enable, but it's easy enough to tell by looking at the card. Once you put a jumper on the right pins, restarting the Aver software should enable the next 4 channels (which are analog only, not IP). Let me know if you're not sure and I'll take a look at mine when I get a chance.

 

You can then connect via standard 2 pin with BNC connectors at the other end. The main thing missing is the slot bracket that anchors the BNCs, but you could always make a bracket interface using, say, a DB9 connector.

Share this post


Link to post
Share on other sites

Thanks for the help. I never thought about that... but now that you bring it up, there are no electronics in the thing.... just outputs. I'll give that a try if I don't find a card anywhere. Thanks.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×