Jump to content
rzant206

Wiring for my camera

Recommended Posts

 

I purchased a cheap camera and the manual was less than helpful. After several emails with product support my question was not resolved. I am hoping someone here can help me. I would like to know if the sockets labeled Z F C are for a remote switch setup for zoom focus and C (I'm not sure what this is for). The A B i know is for another 12 v power connection which I assume is for the motor within the camera to operate the functions. I have attached a picture as this is a general camera purchased from overseas. Any help would be appreciated.

camera.thumb.JPG.8a5dafe6376cb372a08c9033c7eedfd9.JPG

Share this post


Link to post
Share on other sites

Hi. A and B is for control from a dvr or controller

 

A is + data

B is - data

 

It will be marked up on your dvr as either A and B or rs485 + and -

 

You will need to go into camera menu to find its protocol

Share this post


Link to post
Share on other sites

I was doing some reading and the 'C' is common so should I be able to use a double pole double throw switch from 'C' 'F' & 'Z'? then this would be my remote focus and zoom?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×