Jump to content
Sign in to follow this  
heaton231

Camera picture loss after a few minutes

Recommended Posts

[bETTER THAN 1280TVL] KARE® 4CH CCTV DVR System & 2x HD Megapixel Indoor / Outdoor Security Bullet Cameras (1280x720 Pixels, Quick Access Over iOS / Android, H.264 Compression, 36pcs LED for Night Vision, Email Alerts & Motion Detection, IP68 Waterproof and Vandal-Proof Housing, Black).

 

Hi Guys,

 

I purchased the above from amazon, I'm a spark by trade so don't do this usually. This is being used in a block of flats. The cable runs are around 100m and I'm using 2 cameras. I'm using the pre-made cables which are joined (sorry). When I boot the DVR pictures are great but after a couple of minutes the pictures start to degrade and then disappear completely. If I reboot, they come back but then pop off again. I've changed both the DVR and PSU and still the same. I'm pretty sure I'm going to be told the cable is pants but are there any tests I can do to make sure?

Many many many thanks for any help!!!

 

Paul

Share this post


Link to post
Share on other sites

Two of my cameras run that far, but with old better quality cable, but I am noticing that my cheap computer is objecting to all these cameras, on my other computer it is much better, are you using a monitor?

Share this post


Link to post
Share on other sites
Hi, yes I am but it's not the monitor. The cameras are dropping!

 

 

Hi. The cable kits are cheap and are not for cctv even though the sellers say they are.

 

Go with cat5 with baluns ..... 1 pair for video and the rest split for power

Share this post


Link to post
Share on other sites
Thanks for that, I have some drums of shotgun cable. Would that be OK as an alternative?

 

Cheers.

 

Paul.

 

Hi. Yes you are good with shotgun.... you will also see a little improvement with coax as that is 75ohm unlike the cable kits you are using now. Also the power conductors are too small and not allowing the amps your cameras need

Share this post


Link to post
Share on other sites

Hi, thanks for that. My butt is on the line so I need to get it sorted.

 

It's strange because the images are really good for a few minutes and then gone. Do you think it's the voltage getting through to the camera that's the problem?

 

Many thanks.

 

Paul.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×