Jump to content
kerner

Cameras have alot of static or 'snow' in picture?

Recommended Posts

Went to check my cameras and all have static/snow, some with loss of signal that comes and goes. Tried a new DVR box, same thing. Suggestions? Is it as simple as the power supply to the cameras feeding interference but still sending power?

 

I did order a new power supply to try.

 

I can see picture in cameras, things seem to be functioning properly, just the "snow" or some kind of interference in signal, but it's consistent over all the cameras so I don't think it's one camera or one cable.

 

Q-See systems if it helps. QS-458 and QTH-84, both DVR's same issue.

391651204_thumbnail(64).thumb.jpg.5aaf4e7e02af86b7672b94b9da96f14f.jpg

Share this post


Link to post
Share on other sites

It was the camera power supply should anyone run into this in the future, ordered a replacement off ebay for $15, and fixed the problem.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×