Jump to content
Sign in to follow this  
caughtem

Need some advice

Recommended Posts

In an attempt to make this succinct I am looking for some way to have the monitor display only the camera or cameras that are detecting motion and at the end of the event screen again goes blank. I can play back the what the dvr has recorded for the day and the only thing that is displayed is the camera that has recorded motion so I feel this may in some way be possible. The only way that I have been able to accomplish this so far is to leave one of the cameras recording continuously then set it to playback a few seconds behind the recording. The other three camera screens are blank until motion is detected. Any suggestions would be appreciated.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×