Jump to content
Sign in to follow this  
delpiero

Stop the logo page dvr

Recommended Posts

Hello. i have a GREAT (brand) dvr. this dvr stopped in logo (first) page. all of the voltage is correct! can u help me? i have'nt bios file for this dvr.

 

model : great gt-2204 & gt-2208

IMG_20140205_173433.thumb.jpg.69d1e9fe5cbc376c1554772e06c1e829.jpg

Edited by Guest

Share this post


Link to post
Share on other sites

The voltage maybe correct but the amperage may not be. Try a different power supply and also try without the hard drive attached.

 

Is your power supply 3.5 Amps ?

Share this post


Link to post
Share on other sites

my power is 5 amp and i check my dvr with another power, but ...

 

i tested without hard disk and this problem not solved!

Share this post


Link to post
Share on other sites

Ok try with battery out, disk unplugged. Also unplug the cable that goes to the front panel.

 

Were any of the cameras outdoor cameras? Was this in a commercial environment?

Share this post


Link to post
Share on other sites

I unplugged that goes to the front panel and out battery, but this problem not solved.

 

No. it is'nt in the commercial environment

Share this post


Link to post
Share on other sites

I was hoping for a jumper pin that creates a reset. Anything like that on the board? While running short the jumper or move the jumper plug.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×