Jump to content
Sign in to follow this  
richard951

Mini NVR foscam protocol

Recommended Posts

I have a Mini NVR 8CH upgraded to Xvision firmware and added few iX protocol (i12,i13,i18) for various ip cameras. Master Version: V4.0[20141030]. Hardware Version V4.0

 

1. New cameras work with i9 and i13 motion detection flawlessly. I managed to get Escam QD300 to accept i12 (file: i12-20140607.update) protocol but no motion detection. System would give me "Save parameter error" if I try to change motion sensitivity or alarm parameter. If you have a correct private i12 protocol update to work with this camera, please reply a link.

 

2. I also have foscam FI9821W V2, which can be connected as Onvif protocol, so no motion detection or PTZ. Foscam FN3104H NVR is a 4CH similar to other Mini NVR but have Foscam protocol in their firmware. Is there a private foscam protocol to be added to aftermarket mini NVR?

 

Thank You

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×