Jump to content
Sign in to follow this  
tonych

Swann nvr460 regular video loss

Recommended Posts

I have 3 cameras connected to my Swann NVR-460. When I first installed them, they were fine (after advice on this forum). Having not used the system for a few months, I reinstalled the whole system with no problems, except that the cameras connect through wifi, the clock runs, but after about 20 seconds (but this varies a lot) the clock stops, the wifi symbol on the camera image disappears, and then I get the message "Video Loss". Half a minute later, it comes back on. I have tried rebooting the system, but it seems to make no difference. The main wifi signal in the top right of the screen shows full signal all the time. Any ideas?

Share this post


Link to post
Share on other sites

I had the same problem with two of my cameras that were a little farther away from my NVR. I finally solved it by putting a wifi repeater halfway between the cameras and my NVR. That solved my problem. They are much more reliable now.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×