Jump to content
markc_uk

Escam Qd300-WiFi and mini-NVR (N6200-4e) - Motion Detection

Recommended Posts

Hi,

Could anyone advise. I have a couple of Escam Qd-300WiFi and Escam nvr (N6200-4e).

 

I finally got everything 'nearly' working (including email alerts with attachment following a Dec firmware update to the camera, supplied by Escam support). However, I still have an issue with motion detection, where recording will start OK (I see "motion start" on nvr log"), but it never stops recording until I manually force a stop.

 

Escam support do reply from time to time, and did advise the WiFi variant only supports Onvif, where as the QD300 (non-Wifi) also supports I12 protocol.

 

So it seems I need the QD300/I12 product for motion detection to fully work (i.e. start on motion, then end when motion stops). The nvr has a parameter that allows both pre and post record times to be set, which also appears to work fine.

 

I guess there are two questions;

1. Can I load firmware of a Qd300 onto a Qd300WiFi and benefit from the I12 protocol?

2. Is there a way to add I12 protocol to Qd300WiFi?

 

Failing that, I guess it's a case of buying a Qd300 and seeing what happens.

 

Any thoughts?

Mark.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×