Jump to content

VideoQ

Members
  • Content Count

    7
  • Joined

  • Last visited

Posts posted by VideoQ


  1. This stuff has been deployed all over the world and is still in use in many industrial environment and will be for many years to come. Sadly, the company has tanked due to recent changes in ownership. After ****ter Electric destroyed the company it was bought by some investment company for a short while, and has just recently been bought out by big mother M (Motorola)

    Your best bet is hunting ebay and probably keeping everything on Digital Sentry units. The analog cams you can keep on a single 16ch encoder which only uses one licence. 

    Pelco has dumped all other products in favor of their latest failed abortion of a VMS: VideoXpert. I don't see it taking off, and Motorola is likely to scrap it. 

    I would not invest in any new pelco products or services.  


  2. Hi Andy, the camera they gave you is a network IP Camera, NOT an analog camera (and an expensive one at that!). That RJ45 is for a network interface NOT analog video.

    It cannot be used as an analog camera. Your best bet is probably trying to repair the existing analog esprit unit you have, parts come up on ebay from time to time.

    It could be something simple as a burnt out power supply or camera unit.


  3. I am trying to make myself a cable, do you know the pins that correspond to the video output? 
    On the IPS-Cable there is a BNC coax tail coming off it, I assume it went to the unused RJ45 pairs 4 and 5 (blue and white/blue) but not getting video out of it

    Do you happen to have a full pin-out of that on board RJ45 port that is built in to the Spectra IV dome drives ?


  4. Hi, so I am trying to make the Pelco "IPS-Cable" to update the firmware.

    I saw a post here from another member back in 2012 showing the pin-out for the IPS-Cable.

    But there is nothing showing which pins go to the video output (BNC connector coming from the IPS-Cable) I thought it may be the unused RJ-45 Pins 4&5, but no luck.

    Does any one have a wiring diagram for that on board RJ-45 port that is built in to the Spectra III and IV series dome drives ?

×