Jump to content
CCTV4CrazyMe!!

Cameras going black with white wavy lines at night...

Recommended Posts

Hello,

First time here and need some help?...

Have a CCTV system that has worked great for 6 years continuously. The cameras work fine during the day, but at dusk, they go black and have wavy white lines on the monitor. It started with two cameras, then two more and now, all are doing it(6). This has happened over the last two weeks. I'm thinking it has something to do with the IR, because they used to work great at night.

Is this something that can be fixed with these cameras or do they need to be replaced?

Thanks

Share this post


Link to post
Share on other sites

Thanks for the replys...

I have a multimeter... can I check power supplys with it or do I need something specific...? What am I looking for, volts or amps or both? The power plugs are the mini type plugs, male/female.

Ground Loops?... Huh?

 

Thanks...

Share this post


Link to post
Share on other sites

1. How/where are the cameras powered? Locally, or a single PS for all?

2. Measure the voltage out if a single PS at the supply under load. Then at each camera under load. That may require some creative wiring depending on how they are connected (dongle w/ jack or screw/push in terminals).

3. Is anything grounded separately? (for ground loops, you will have to search on that subject, it can be complicated if that is the problem)

 

If voltages are ok, at least 9v, preferably 10v for 12VDC depending on the camera. (for AC; I'm not sure of for what a cut off voltage would be) for a centralized PS.

 

The easiest way if you have a single PS is substitute another supply and see if that changes anything.

Share this post


Link to post
Share on other sites

OK... I ordered a couple new cameras... plugged them in and one is working fine in the day and in the night. The other has a problem like my existing cameras and is being returned. Great night vision on the one that is working. The power supplies are working fine, not the problem... I ordered some LED boards and was supposed to get the FY-3036 to replace the ones in my existing cameras, but received FY-5036. The FY-3036 has one plug to plug in and the FY-5036 have two plugs to plug in. Either way, they didn't work, even though the seller is saying they are the right ones, when they are not. Tackling that battle now...

When installing the good one(new camera) , I noticed a clicking sound coming from the camera when I put my headlamp on it(installed it at night). This camera has great night vision. The others I have aren't clicking when I point a light on them. For some reason , I believe this is what is wrong with the other cameras.

Again, they work fine during the day, but at dusk and night they go black and have no night vision. They did have night vision for years, but not now.

So, what is the problem?

Thanks

Share this post


Link to post
Share on other sites

Upon closer inspection and some help from YouTube. It looks like the IR Cut Filter is stuck in the closed position which is keeping the camera(s) view black at night. The LED's are working at night, but the filter is working against the LED's... no night vision.

Opened the cameras up and it looks like an electrical shutter and not a mechanical. This explains why the new camera was clicking on and off when my headlight shined on the photocell(LED board). The others that are not working are not clicking(stuck shutter:IR Cut Filter).

Guess I need new cameras?...

Thanks for the help...

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×