Ryder 0 Posted October 12, 2016 Hi, I did try to search the forum but could not find anything. I will be getting a swann system installed, with 4 cameras, 2 for the back and 2 at the front. Installer said best way to do it is to take all 4 cables out the back from the same point (as DVR will be in the upstairs room at the back of house) and then run the 2 cables for the back 2 cameras at the back along the outside wall and for the front 2 cameras, just throw the cables over the roof to the front of the house. Is that ok to throw over the roof? Cables seem quite thin and I told him there will be no protection from rain or wind on the roof, and cables scraping over roof tiles will wear them out. He said everyone does it like that. Seems wrong to me. Is that really how most people will do it? If not what can I say to him to convince him otherwise? Share this post Link to post Share on other sites
tomcctv 187 Posted October 12, 2016 Hi. No it's not the right way for doing it. It sounds like your installer is just using a DIY kit .... The cables are thin and should not be used. Plus you are talking about analog .... Look at IP system or at least cvi or tvi Share this post Link to post Share on other sites
jeromephone 6 Posted October 12, 2016 NO cables need to be protected should be outdoor rated if exposed, Dump this guy Share this post Link to post Share on other sites
Boogieman 1 Posted October 12, 2016 If not what can I say to him to convince him otherwise? You're fired? Share this post Link to post Share on other sites
Ryder 0 Posted October 12, 2016 Thanks guys, I'll see what I can do. Share this post Link to post Share on other sites
