woody

Its not my Microwave its the neighbours and it is close to the receiver, I have just finished hardwire connecting my old video camera to the box and will give that a run just to prove to myself that it is not the DVR. Will then try getting the camera and receiver closer together as you suggest. Thanks again

Hi, This is my first post. I have a MU055 4Ch DVR and have 2 wireless cameras attached, However I keep finding it stops recording if I get a video loss signal - normally caused by next doors microwave oven which they use a lot. Has anyone else had this problem ? If so is there a fix? Regards Woody

Thanks for the replies it looks like I will have to get hard wired cameras for recording purposes. Regards Woody

ispy, Thanks for the reply, I am sure that most of the signal loss is due to microwave useage - you get the tell tale lines on the screen. I have tried ugrading the arials to 9dBi High Gain, which improved reception slightly. I have it set to permanent record not motion. Here is the full spec of the system. (Copied & pasted) COLOUR WIRELESS HIGH RESOLUTION DAY/NIGHT CCTV CAMERA WITH RECEIVER (906D) AND 4 CAMERA DVR400M VIDEO RECORDER WITH MOTION DETECTION AND 250GB HARD DRIVE CAMERA AND RECEIVER FEATURES Image sensor: 1/4-inch CCD Resolution: 420TVL Sharp picture display Night vision (effective range: 15m) Alloyed shell, weatherproof structure for outdoor installation Built-in microphone for audio monitoring 4 optional channels to avoid possible interference Up to 100m (330-feet) transmission range in open space Specifications: General: Transmission frequency: ISM 2,400 to 2,483MHz Modulation mode: FM Operating frequency: 2,414, 2,432, 2,450 and 2,468MHz Unobstructed effective range: 100m (minimum) Operating temperature: -10 to +50 degrees Celsius (+14 to +122 degrees Fahrenheit) Operating humidity: ≤85%RH Camera: Imaging sensor type: CCD Picture total pixels: PAL: 512 x 582 NTSC: 512 x 492 Minimum illumination: 0 Lux Night vision range: 15m Bandwidth: 18MHz Current consumption: 120mA (IR off) and 270mA (IR on) (maximum) Power supply: +12V DC Receiver: Demodulation type: FM Intermediate frequency: 480MHz Antenna: SMA (50 ohms) Receiving sensitivity: ≤-85dBm Video output signal level: 1.1 ±0.2Vp-p, 75 ohms S/N ratio: >38dB Audio output signal level: 3.0 ±1Vp-p, 600 ohms Current consumption: 250mA (maximum) Power supply: +8V DC Weight: 200g DVR FEATURES 4 Camera DVR With Motion Detection and 250GB Hard Drive DVR has motion detection recording allowing the DVR memory to last much longer. Simultaneous, real time digital recording from up to 4 cameras Record continuously or on motion activation Time and date stamps all footage Connect to any TV or monitor Record up to 6 months continuously Records up to 25 frames per second across all cameras (25fps per camera) 250GB hard drive included Employs proprietary compression format (H263+) Easy installation with plug and play connection Professional quality recording with variable recording time solutions Connect the DVR to a TV and VCR to get footage off. Fully complies with the Data Protection Act.

They are an old couple that we help a lot and know that they do all their meals by microwave - the video loss ties in with their meal times, our microwave causes the same problem but we hardly use ours.