vin2install

It will be WAY better than your hughes net for sure like night and day. Plus now you can forward ports with your modem.

Its going to be slow regardless since he is on satellite

That particular modem is locked into dhcp. You cannot do any port forwarding unless you pay 20 dollars a month for static ip from them

Just give him what he wants because one has IR's the other does not

Why don't you just daisy chain it at the DVR and run that one set of wires (+ from PTZ1 and - from PTZ4) into your dvr. You dont actually have to run wires around the house and daisy chain at the PTZ's.

try putting the dyndns account into your router instead of your DVR

http://www.everfocus.com/support.cfm

Welcome back!!!!

The effective pixels on the Effio-P is 1028x508. I am not sure of the Effio-E's effective pixel count as we dont have any of those.

Bridge your Linksys to your modem/router.

You are probably connecting it wrong. The RJ45 Cat5 of the DVR plugs into your network. i am assuming you have a network keyboard. So that plugs into the network too. The RS485 of the Dome would plug into the controls of the DVR. If you dont want to go through the network you can parallel your RS485 connections from the Dome to the DVR and Keyboard

Out of these two the second one is better. Even if it is only 420TVL. Effective pixel is the same for both cameras. Plus the second camera has a Super HAD CCD which is better than the regular Sony CCD. Plus the second one looks like its PAL only so you have to make sure its compatible.

On camera 3 you just have to be kind of realistic. Look how wide and far of an area that you want to cover with a IR camera with limited IR LEDs. To get that picture clear at night you need an ICR camera and lots of IR LEDs with wide angles and strong ones too

Leave the device on DHCP if it grabs an IP address then your ethernet cable is ok

Make sure each ptz is on its own address

What problems or visual artifacts did you notice when you did not twist AC power? Best, Christopher I think it keeps it from inducing interference into the video wires

I usually still utilize the twist even when doubling up on power somehow in my test here it seems to work better.

You need a WDR camera for those situations.

try ffdshow

Usually you have to select custom ports or have to manually define a new application to use custom ports that are not on the application list. As for the router not detecting it but you know its on the network you can always assign the rule manually to the DVR IP address.

Maybe you have a bad ethernet cable.

Are you considering the amperage a the source when you are making this recommendation? With a power supply that has 1A at the source with 28VAC and with 16 gauge cable, your voltage drop will be around 9V at the receiving end, which will be around 18-19V available for the camera. I do not think camera will perform correctly. If someone uses 12 gauge cable and pushes 1A with 28VAC at the source, then the camera receiving end could get roughly 24VAC (voltage drop will be roughly 4VAC) according to the chart with Altronix... In the real world this could be slightly different, but not much... Higher amperage power supply will improve the voltage drop per 100' on type of gauge cable... It all depends on the current draw on his cameras. If he is using a 24vac camera that only draws 250mA with 28VAC power supply he should have no problem hitting his distances of 1100ft

Than your current draw will jump up considerably and you might need to go to a lower gauge to compensate.

RG59 95% Copper Core and copper braid gives you 750-800ft RG6 95% Copper Core and copper braid gives you 1500-1600ft

With that distance if you use a 16gauge wire with 24vac cameras and a 27-28 VAC power supply than you should be fine. Assuming that you aren't using cameras with heater and blower or PTZ. Do not go 12vdc for that distance.