Fluke

Hello Guys

I was having similar issues but finally manged to get it working, was wondering if you experienced the following.

If I set the system up on the bench supply I can control my samsung camera via my control, over coaxial cable.

However when I install the camera say 50 meters away I cannot control the Camera at all either by the control or through the DVR onbard PTZ controls.

The picture I am getting is crystal clear.

What could be my issue, where should I start?

Hello All

I have the following Kit

1. Samsung SPC-1010 controller

2. Samsung SRD-1650 DC DVR recorder

3. Samsung SCP-2370 THP Camera

I can connect the controller directly to the camera and all PTZ functions work correctly.

What I need to do is connect the controller to the DVR and the camera into the DVR, so effectively i send the ptz command to the DVR which in turn sends it to the camera. (this way we can extend the system to multiple camera and control all cameras)

I believe the camera is one which uses the coaxial to transmit the PRZ commands.

ON THE DVR I HAVE THE FOLLOWING:

TX + & -

RX + & -

on the controller there is

TRX + & -

TX1 + & -

TX2 + & -

TX3 + & -

So how do I connect the the Controller to the DVR?

I am heading in the right direction now further reading after searching "coaxitron" make the matter a lot clearer.

Is there an adaptor I can use to connect these panasonic camera to the following controller?

http://www.meritlilin.co.uk/assets/Keyboard%20Controller%20(PIH-800II).pdf

Or am a barking up the wrong tree?

Reading further into this I believe that the coax cable send the video AND the telemetry date through the SAME cable.

I am now hooking up a controller to see if I can access the setup menus.

Please still reply if you can offer any guidance.

Hello Guys

I am new to this forum and would like to say big hello to all of you.

Right down to the nitty gritty

I have 2 units of the Panasonic WV-CS320,

The link below will take you too a PDF version of the user manual.

http://www.ecdltd.com/manuals/panasonic.pdf

I can get power to the unit fine and the video output is also fine, problem I have is how to I set the camera up it is currently doing a 360 pan and I need to edit this plus other settings.

How do I get to the setup menu?

According to the manual I should use a controller to enter the menu, this is the problem I do not have one.

Do any of you have any experience with this model?

This link http://www.info4security.com/story.asp?storyCode=1038157&sectioncode=9

states that the video cable also carries telemetry data I have split open the unit and can see at least 14 cables however a visual inspection along with a continuity test confirm these do not enter the camera unit.

Any guidance or help would be much appreciated.