cycop

Do you have your DVR set with a static IP or did it just pop up with that IP address once?

 

Also, be sure the Windows Firewall isn't on. That is one most people don't check since it comes from XP on by default.

 

its using static IP. firewall isn't on too

 

And you have EVERYTHING set up the same? Static internal, static external, forwarded port 80 to the internal IP within the router setup?

yes

Do you have your DVR set with a static IP or did it just pop up with that IP address once?

 

Also, be sure the Windows Firewall isn't on. That is one most people don't check since it comes from XP on by default.

its using static IP. firewall isn't on too

anyone managed to solve this problem?

hi,

anyone knows how to sound an alert when motion is detected for diginet dvr software?

I just installed a KMC-4400R DVR with DigiNet software on my windows XP PC. The motion capturing is very slow and it hangs most of the time resulting in some images not being captured instantly.

How to resolve this?

thanks

if I see horizontal lines with distortion on the screen does it means that my power supply is faulty?

how do i know if it is pirated card or not?

video acceleration settings? lower that setting........

 

motion causes PC based DVR's to "jump" in CPU resources........

Why the problem does not happen when i only have 2 cameras?

Can you take a camera, and plug it in directly to you PC DVR?

 

If the cable was a long run it would cause a voltage drop that the camera may not agree with. If it is a long run then the video may fall apart before it gets to your DVR.

 

If you can try a camera locally this will tell you if it is a power/video problem or the DVR itself.

 

What kind of mother board are you running? What chip set is it?

i tried connecting the camera directly to DVR same problem.

i am running it on P4 1.8GHZ with 1GB RAM

i tried with different DVR settings same problem.

how do i enhance the signal for BNC cable?

I tried with another BNC cable the motion detection screen freezes too.

I am think if that could be due to DVR card problem now

any idea how to confirm that?

what does Low signal means?

bnc wire is bad?

could it due to PC or DVR card too?

I am using kodicom 416 card connecting to 4 cameras using motion detect turned on. When there is an activity detect on 1 of the cameras, the camera screen freezes for few seconds and sometimes does not even capture the activity.

This problem does not happen when I am only using 2 cameras.

What could be wrong?

i am using Kodicom card and dignet

any idea?

the DVR alarm works with motion detection which produces beeping sound from the PC speaker. How can I direct that to mp3 sound?

why is it that the image on TV is so much better than the image from my DVR card. What could be wrong here?

does the BNC-RCA cable normally comes with the TV?

Hi, is it possible to connect the CAM to a TV directly?

how to do it?

thanks

how to fix blur image and discoloration of this card?

Use their feet on the floor, you'll have to premeasure and mark. You can use postit notes and then configure the DVR for the action you want taken. You may need to use a loop out to get it to process the feed totally different on another channel if you want to use the camera for normal MD recording too.

sorry i don't understand what you mean

how does the DVR detect that someone is 2m away?

using the cam ?

hi, can the DVR card play a sound when someone is detected 2m away ?

any help?

Is CMOS cam better or CCD cam better?