ilovetacos1756
-
Content Count
2 -
Joined
-
Last visited
Posts posted by ilovetacos1756
-
-
I installed a system for a client 4 months ago that included four CM-512 Open Eye PTZs. They are connected to an Open Eye DVR. I returned to add two more PTZ's and all was well.
About two months ago one of the cameras developed an issue. The image became very distorted and blurry.
I replaced the camera with a factory replacement.
I have replaced the BNC's on both ends of the cable.
I installed ground loop isolators on all cameras in the system.
I moved the power connection to a new output on my Altronix 24vac power supply. The PS is a 16ch unit of which only 8 are being used.
After my last trip to the site the camera looked great for three weeks and now the problem has returned.
If i reboot the camera it will look okay for 24-48 hours and then overnight will revert back and look like junk.
I am out of ideas and my customer is losing patience.
Has anyone seen this before?
Distorted image problem, any ideas?
in General Analog CCTV Discussion
Posted
Camera is running over Genesis RG59-18/2 Siamese. Wire run is approx. 275'.
Oh, BTW did I mention the camera is 40 feet in the air?
Which makes troubleshooting tougher.