R1966

Resetting the camera should return the Auto focus mode to AUTO L...

and it is made in that mode, but gives me the problem for about ten minutes puts fire perfectly but after each shot back blurry

google onvif device manager from sourceforge

my camera is not network

Another way is get ONVIF device manager v2.2.250 ... it has a hard reset option

what is? I do not know what it is, my camera is not network

You can reset this camera via the osd menu.

 

Go to Special Setup Menu, Push SET to the right of Camera Reset, and then push the F4 button.

 

Camera preset position, auto pan, patrol, rs485, blemish compensation pattern and password settings are not changed...

This method is known him, I wanted to know if there is a method where you clear all bringing the cam to the factory settings, in care did a thing to solve a problem of focus

of some one you know if you can do a hard reset of the camera, and how?

I suddenly have this problem on a PTZ camera Panasonic CW960, I have 8 shots preset the camera suddenly, despite the autofocus set, do not put more in focus, if I turn off and relight the camera for a few minutes to a few hours reminisces perfectly then back again blurred

don't see anywhere in the manual for the camera that says PELCO protocol can be set on this camera.

looks like a mismatch on your set up- would be my best guess.

the user data with the camera would seem not, from this document Panasonic instead

I was able to connect with the keyboard dome in question, setting both the keyboard and the camera with Panasonic protocol can operate perfectly the cam in the functions of pan, tilt and zoom, can store the default locations but I can absolutely to enter the menu the camera. Setting keyboard and dome with Pelco P (from Panasonic had told me that it was not possible but by manual found on the net instead) command with difficulty the camera movements in the sense that sometimes takes them, sometimes takes them wrong I log menu by calling preset 95 but I can not get into the submenus. What could it be ??? protocol compatibility problems? problems of noisy line through the data cable in the same conduit with 220 volt power and video cable and being spliced about half of about 15 meters of cable ?? There are suggerrimenti to solve the problem with Panasonic protocol or Pelco ??