How many cameras single with a POE swit and EHN200 ENGINIUS

[andresdamas 0]

here is the design I am using 3 ehn 200 enginius antenas and each antennas will have a 8 poe switch with 5 3mp cameras attached to it, and 1 EHN210EXT antennas as receiver, I know you can configure up to 5 ehn200 with out problem using 2.4 mhz up to a mile away, my question is :

 

how do I measure the bandwith ? no software is build in enginuis to measure they said 300mbp but who knows

 

AM I over loading the EHN200?

 

the distance is one enh200 300 feet and the other one is 800 feet away

 

 

ANY SUGGESTION? have anybody have push the bandwith the limits on enginuis antennas

 

Thank you very much for you rtime

[Roman.CA 0]

Its a bit too specific and not clear what you mean. try to do spell check too.

 

To measure bandwidth of each camera you can use router than has DD-WRT firmware, like Buffalo N300 or buy refurbished router e.g. linksys E2500 for $20 and flash DD-WRT firmware (complicated), then on statistics tab you can see bandwidth.

 

Or just buy everything where you can return within 30 days no questions asked and see for yourself if that setup works.