drkailey 0 Posted October 8, 2017 QC828 POE NVR was running pretty flawless for about five years but quit recently and won't boot. Tried w/o hard drive, with two different hard drives, checked both NVR and camera power supplies, nothing on the board look fried and the caps look new. Fan comes on and hard drive spins up but no "beep" and nothing on HDMI output or video out. Can't access through Smart PSS, no video. Ideas? Share this post Link to post Share on other sites
drkailey 0 Posted October 9, 2017 Thanks for the reply but I was told by Q-See support (and read) it should boot w/o the hard drive. Apparently it's a re-branded Dahua. Is it possible to re-load the firmware if it doesn't boot? Share this post Link to post Share on other sites
