Pando 0 Posted September 30, 2021 Hello, I have a IPC-PFW8601-A180 panoramic camera (3-lens) that is bricked. I know the hardware is working as it draws power from the switch and red LEDs blink every 4 seconds where the IR strip is. The camera was initially working fine. During initial setup I pressed the Splicing > Start button (which supposedly adjusts the splicing of the 3 images for a better match). After it was done the camera just displayed garbage. I tried updating firmware and after that it's bricked, not responding to any pings. Pushing the reset button doesn't do anything. I know there are some procedures out there that can push a firmware into it using TFTP or serial port etc., so if anyone has any ideas please post. Thanks Share this post Link to post Share on other sites
