Jump to content
Tubdub

NV5000 lite I/O functions help

Recommended Posts

I have an NV5000 lite and also have the audio daughter card with the I/O capability for sensors and relays.

 

I would like to make use of the I/O functions by connecting a couple of PIR sensors and a door sensor. I'd then want the system to record when something sets off the PIR or when the door is opened. I can probably work out the software side of things, but I'm not sure about the hardware side.

 

Does anyone have any information on connecting sensors to the system? Do I need a certain type of PIR/Door sensor or will most types work? Below is the pin out for the I/O connector on the card. As I don't yet have the PIR & Door sensors I'm not sure what wires they would have so hoping someone can give me an idea of what to expect and where things should be connected.

 

Pinout on the card:

1: INPUT SIGNAL 1+

2: INPUT SIGNAL 2+

3: INPUT SIGNAL 3+

4: INPUT SIGNAL 4+

5: OUTPUT 3 - Normally Closed

6: INPUT SIGNAL 1- (GND)

7: INPUT SIGNAL 2- (GND)

8: INPUT SIGNAL 3- (GND)

9: INPUT SIGNAL 4- (GND)

10: OUTPUT 3 - Common

11: OUTPUT 1 - Normally Open

12: OUTPUT 1 - Common

13: OUTPUT 2 - Normally Open

14: OUTPUT 2 - Common

15: OUTPUT 3 - Normally Open

 

Thanks in advance for any help.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×