bigspud

just got it from geo home, installed okay.

version says its 8.6.1.0 in app.

is it possible without ie or qt.

mjpeg live view works okay with dolphin and chrome browsers.

it would be nice if the geo software had an option to leave a indicator of where on the video or jpg the motion was detected. the only thing that i found comes close is the object index detection which can show the colored rectangles.

i hope it works, v8.5.7 no longer supports xp, according to geo install notes. anyone tried it?

i have a gv800a pci-e in a intel i3-2100 h67 mb, and it runs rock solid.

i tried an older pci dvr non gv card, and it wouldnt work either, pci-e is the only option.

h67 intel mb uses pci bridge chip, not compatable with gv pci cards, pci-e will work.

unfortunately geo software lacks the very important feature of marking or showing sprites where the motion trigger occurs, this makes it difficult to set up optimum sensitivity and zone selection.

you could try using object indexing to see what is causing the triggers, since it shows big blue squares when triggered.

sandybridge no native pci, mb use bridge chip(FAIL).

i emailed them about FBR and large font problem, got reply in less than 2 days.

what stupid place to put geo files, fbr does not save all settings, and fbr is unusable if u use large fonts in windows. the geo programmers must be real amateurs.

sandy bridge chipset mb use a pci bridge chip, many people are having trouble with this, do not use these.

i would like this too, 320 res is not good enough for todays displays.

i wish it had option for 640x480 email photo.

320x240 just aint enough.

i run my gv800, homeseer, and hd sat tv on my one computer 24/7 no problem.

e8400cpu,2gb ram, ati 2400pro, win7 32bit.

cpu=50% when playing hd video, 25% sd video.

ram=40% use playing video.

i use dexpot and a hot key to switch between tv screen and geovision.

i can make my gv800 card do the black screen signal lost thing by enabling the power saving features of the asus motherboard. running full chipset voltages and gv800 works fine.

@1.2ghz about 4minute boot time vs about 2minutes ar 3ghz.

when running computer 24/7, boot time is not a factor.

i think lack of ram would do more to sloww down gv software, since it uses so much of it.

v8.3 works fine on my e8400 underclocked to 1.2ghz that running a gv800 with 8 cameras going. its only when i enable power saving app(asus epu6) that i get video dropout. my guess is it cuts pci power and does this even at default 3ghz cpu speed.

have not seen a camera yet that does this.

ir led cameras attract insect which trigger motion detection.

i would like to see this feature added also.

any way to schedule different video attributes.

one for daytime, brighter for nightime.

ati2400hd gv800s v8.3 software

i solved problem by turning off the dd overlay.

i hope its not too important.

ati2400hd has so many settings and ccc is a mess.

i have adjusted each cameras brightness in settings, but when motion detected and camera popup activated ,the video is back to default, which is way to bright.

is there another brightness setting that i missed?