nikey22
-
Content Count
8 -
Joined
-
Last visited
Posts posted by nikey22
-
-
looking at the http://www.dahuasecurity.com website, I see:
DH_HCVR5108H_Eng_P_V3.200.0001.30.R.20170807
In the applicable models, it shows: HCVR5104HC as one of the units. I'm not sure if this is yours
I'm unsure what the HC stands for?
The NTSC version is on the website there as well (probably the one you had factory installed):
DH_HCVR5108H_Eng_N_V3.200.0001.30.R.20170807
use at your own discretion
since it is branded ADT, it would probably be easier to call ADT and see if they have their own "general" firmware variant of the dahua ones.
Good luck.
-
you probably have:
DH_HCVR5x04-S2_Eng_P_V3.200.0004.13.R.20171021
in your system from factory.
On the www.dahuasecurity.com website, I can see the following firmware, same timestamp however:
DH_HCVR5x04-S2_SpnEng_NP_V3.200.0004.13.R.20171021
The 'NP' should allow you to toggle between NTSC/PAL.
Global -> International -> Support ->Download center -> Firmware.
Post back here how it went, good luck.
-
bad hard drive? Try with a new hard drive.
-
I will ofcourse being doing update in order, but my question however was, is it possible to revert back to a previous firmware version if necessary.
-
quick question:
If you install a firmware with date: 080601, can you return to firmware date: 171229 if you wanted to?
In other words can you go back to an older firmware; will it allow it? thanks.
-
@tomcctv
This DVR has a 9-pin RS 232 port on the back.
Can we use this with a null modem cable to connect it directly to a computer for telnet access? (console access) for example if there is a need to update firmware a different way?
I noticed in your other post you mentioned that all newer DVRs don't have telnet function anymore, I haven't tried yet with this model.
-
latest firmware?
dahuasecurity.com website:
DH_XVR7x16_EngSpnFrn_NP_V3.218.0000002.1.R.171229
dahuawiki.com website:
DH_XVR7x16_EngSpnFrn_NP_V3.218.0000002.3.R.180601
l brick my dvr dahua
in DVR Cards and Software - PC Based Systems
Posted
have you been able to solve this?
It looks like the correct firmware might have been:
General_DVR0404LF-AS_3104H_Eng_N_V2.608.0000.7.R.20170312
But if you can't see your device on the network, you probably can't telnet into it.
If you open it up and look carefully at the board, you will see printed on the circuit board RS232
It will have 3 or 4 pins.
Get an RS232-TTL module, find it on ebay.
I think you can transfer new firmware through using a null modem cable. I'm not 100% sure about this.
I don't know the steps, but I'm sure there are guys here that can do a firmware upload this way.
have a look at this guy's video