valboosky

Hold down the control key when it boots. It will prevent the software from launching on startup

The constant reboots coudl be caused by a hard drive issue. Try formatting all drives except the C: drive. To go to windown, hold down the control key as it is loading windows, this will prevent the software from launching.

You might need to turn that feature off. It's under setup and security.

i know how to reset the pin codes. let me know if you need my help.

go to the schedule menu under setup. if the line is red for that camera, it is disabled. change it to green for active.

The previous statement is incorect. Version 2.6 actually runs on Windows 2000. It is the only 2.x version to do so. It is the LT version of 3.2. If your drives are missing. Go out to windows and look at the contents of the drives other than C: There is a file called volumeinfo.xml open this with notepad. Change the line where it says 1 Change the 1 to a 0 and save the file. You should have your drive back in the software. you will need to add it in the Setup, storage section

Get a USB-422 converter. You can use the one from B&B Electronics (USOPTL4) or the Kantech device (USB-485) the DVR needs to be runnign 4.2 or above and you can use the customer handler from the AD website. Regards,

You have to use a software called Network Client for Remote Viewing. Every Intellex comes with 1 user license for this software. In order to view this from a web page. The Intellex needs to be running version 4.1 or higher. Regards,

with just regular maintenance, change of hard drive, fans etc... the intellex will last for many more years. We have Intellex units with version 2.2 still out in the field and those are from the late 90's. Regards,

is this the windows password? or does it say enter pin code?

What brand of camera is this? model? could help. I know of certain problems with cameras like this when camera blocks overheat and the difference in brightness can cause this.

AD Makes a Pelco P customer handler for the Intellex Ultra. The only thing is that you will need to run 4.2 or higher. I have attached the handler. Good luck Pelco_P.zip

If you still have this problem , let me know, I can help.

you cannot interface the ADTT16E with the AD 4 Channel encoder the AD encoder has a sensornet output and you can control the camera for the web GUI of the encoder. Regards

Sorry, it does not, however it is the only AD matrix that will do UTC